Shield Design for Arduino Mega 2560 R3
As you noticed my 3.2″ TFT screen has 40 terminal pin and almost all of them will be used.
It is not an plug-in and use screen. So i have desing and shield for my LCD . Be aware to enlarge
other pins. Because after our shield design unused pins must not be under the shield as discarded (inert).
Another important point is; Arduino’s output high level is 5v but screens high input is 3.3V.
(I mentioned about that before). I used 330 ohms resistor and 1K ohms in series as a voltage divider.
My design can be shown from photos.
Eylül 12, 2014 tarihinde Graduation Project içinde yayınlandı ve Arduino, Arduinomega, Circuit, Electronics, final project of engineering, Project, TFTLCD olarak etiketlendi. Kalıcı bağlantıyı yer imlerinize ekleyin. 2 Yorum.